Vise Screw Kit Wooden - Premium
Wood Vise Screw - Single Kit Premium
N.B. I have been using this vise for a few years now, it’s definitely my go to vise, but the best tip I can give is work it in tandem with a tail vise, the best choice if you are retro fitting is the HNT Gordon tail vise.
>> Leg Vise Installation Instructions included
>> speed of turn is.... 1/2 inch per rotation
>> parallel clamping action, hardly any racking
>> this solid clamping action still allows you grip a small box without crushing it.
>> for all practical purposes it is a silent operation.
In the box.... One hard maple wood vise screw
Total Length approx:
Hub approx.size: 3-1/2" diameter x 4-3/4" long
Threaded section approx.size: 2-1/2" diameter x 19-1/4" long
Vise Screw is milled from a solid billet of hard maple, no glue joints
In the box....One hard maple wood nut
Approx.size: 2-3/4" thick x 4" wide x 9" long
>> One hard maple wood handle - end grain threaded knobs on both end
Approx. Size 1" diameter handle x 1-3/4" diameter knobs x 16-3/4" length
Two hard maple end grain threaded knobs - approx size 1-3/4" x 1-7/8"
Two rubber O-Rings for use with wood handle and knobs
In the box....One external brass garter set with steel screw kit - "Vintage Finish"
Write a reviewYour Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: